Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Technical Fourms
Carburators & Fuel Injection
Static sync'ing
  • Page:
  • 1

TOPIC:

Static sync'ing 1 year 5 months ago #31304

  • scotch
  • scotch's Avatar Topic Author
  • Offline
  • Sustaining Member
  • Sustaining Member
  • Posts: 1942
  • Thank you received: 853
If you don't have .005" brass-shim you can sacrifice a feeler blade  BUT ONLY IF you narrow it down to 4 to 5mm wide  AND smooth-out the newly cut edges.
This has been giving me a sync vacuum in the range of 5" to 6" Hg. which is a good starting point.

 

 
1980 KZ 1300 sr# KZT30A-009997
Always High - Know Fear !
Attachments:
The following user(s) said Thank You: biltonjim, PaulD

Please Log in or Create an account to join the conversation.

Static sync'ing 1 year 5 months ago #31305

  • dcarver220b
  • dcarver220b's Avatar
  • Offline
  • Sustaining Member
  • Sustaining Member
  • Posts: 879
  • Thank you received: 194
How is it used? Set initial slide height?

Please Log in or Create an account to join the conversation.

Static sync'ing 1 year 5 months ago #31306

  • scotch
  • scotch's Avatar Topic Author
  • Offline
  • Sustaining Member
  • Sustaining Member
  • Posts: 1942
  • Thank you received: 853
Aghhh !    Just when I thought we were making progress !

"This has been giving me a sync vacuum in the range of 5" to 6" Hg. which is a good starting point."

 It pre-sets the throttle-plate Gap.......On the bench.  "Static"  Preliminary setting !

 
1980 KZ 1300 sr# KZT30A-009997
Always High - Know Fear !
Attachments:
The following user(s) said Thank You: zed_thirteen, PaulD

Please Log in or Create an account to join the conversation.
  • Page:
  • 1
Technical Fourms
Carburators & Fuel Injection
Static sync'ing
Time to create page: 0.045 seconds
Powered by Kunena Forum