Another basket case project, but with potentially a different end goal!

Paul,

Well done mate..............you got this far and obviously enjoyed the challenge.
Bet you have learned from the experience ............and wont forget it !

Regards

Pete F
UK

Great job Paul,
You have a very nice and unique ride
I’m sure you learn a lot from mechanics to electrical and everything in between

Eran

Ah, it was going so well....

Vacuum set equally across three carbs, colortuned each cylinder (what a wonderful tool!) except no 4 as I simply cannot get to the adjustment screw - running a little rich, so no biggie. All electrics work properly and it stops well.

So I went for another test ride and it runs lovely however, a slight ticking at idle on front LH side of the cylinder head cover turned at higher revs into a noise that sounded like a chain rattling. ... AAARGH!

I am letting it cool down and then I will whip off the cover to see what is happening.

Paul

Paul,

Glad things are moving in the right direction for you................

Have you fitted a LISKA Metal Idler Gear to your bike ?

Pete F
UK

The fact that I don't know what that is means probably not...

Just looked it up... No I haven't.

Paul

test