master cylinders
- paulb
-
- Offline
- Elite Member
-
- Posts: 200
- Thanks: 21
Re: master cylinders
5 years 21 hours ago
Thanks Gents
I have to say a big thanks to everyone on this site for giving patient advice to a mechanical numpty like myself it is greatly appreciated and is helping me keep my z13 on the road where it belongs
I have to say a big thanks to everyone on this site for giving patient advice to a mechanical numpty like myself it is greatly appreciated and is helping me keep my z13 on the road where it belongs
The following user(s) said Thank You: Kawboy
Please Log in or Create an account to join the conversation.
- Kawboy
-
- Offline
- Sustaining Member
-
- Posts: 3188
- Thanks: 1131
Re: master cylinders
5 years 20 hours agopaulb wrote: Thanks Gents
I have to say a big thanks to everyone on this site for giving patient advice to a mechanical numpty like myself it is greatly appreciated and is helping me keep my z13 on the road where it belongs[/quote
Not a problem. As a matter of fact, I look in to the site about 6 to 8 times a day if for no other reason than a bit of psychological relief during these trying times. Bring it on.
Please Log in or Create an account to join the conversation.
- tackelhappy
-
- Offline
- Platinum Member
-
- Posts: 426
- Thanks: 167
Re: master cylinders
5 years 16 hours agoKawboy wrote:paulb wrote: Thanks Gents
I have to say a big thanks to everyone on this site for giving patient advice to a mechanical numpty like myself it is greatly appreciated and is helping me keep my z13 on the road where it belongs[/quote
Not a problem. As a matter of fact, I look in to the site about 6 to 8 times a day if for no other reason than a bit of psychological relief during these trying times. Bring it on.
Bit off topic for master cylinders, but. Is there any appetite for redoing the home page. The bikes that are featured there have been so almost since the beginning. I have no idea what that might take but only some suggestions of what could replace some of the photo's. EG. Photo's unique to this bike . Maybe Scotch has some good shots of a restored set of carbs. Maybe someone else has one from the bowels of the engine showing how the transmission and drive shaft are coupled. Maybe the euro guys have a photo of the fuel injection setup. We may all have a bit more time on our hands than we did this time last year- any takers ?
" If you can't say what you think, very soon you won't be able to think !
OKANAGAN FALLS. BC ,Canada
OKANAGAN FALLS. BC ,Canada
Please Log in or Create an account to join the conversation.
- Greg Davis
-
Topic Author
- Offline
- Sustaining Member
-
- Posts: 37
- Thanks: 13
Re: master cylinders
4 years 11 months ago
so what size Dia. is the front hole on the front master? It looked to me to be a casting dimple, looking in the bore under strong light did not show like the front port did.
thanks Greg
thanks Greg
Please Log in or Create an account to join the conversation.
- coleface
-
- Offline
- Senior Member
-
- Posts: 42
- Thanks: 4
Re: master cylinders
4 years 11 months ago
You mean the small hole? I tried a .020 lock wire and it didn't fit so smaller than that. I used the needle as mentioned here and saw it poke into the cylinder bore.
Please Log in or Create an account to join the conversation.
- stonehill
-
- Offline
- Junior Member
-
- Posts: 21
- Thanks: 8
Please Log in or Create an account to join the conversation.
Time to create page: 0.186 seconds