TOPIC:

i need the head bolts tightening sequence and torques please if someone could share that with me as my internet is so crap that i can not download the manuals still not even getting half a meg !!

Gimmie a bit. I'll get a photo of that part of the manual and get you some numbers later tonight, in a couple hours. Have a few things to do, but afterwords I'll get you taken care of.

Alright, official service manual instructions are to tighten the cylinder head nuts to 2.5 kg-m (18 ft-lbs.) and the bolts in the rear to .6 kg-m (52 in-lbs.).

Second pass, torque the nuts to 4 kg-m (29 ft-lbs.) and bolts to 1 kg-m (87 in-lbs.)

Put it together, warm up the engine, let it cool down, then re-torque.

many thanks indeed but 87 ft for those little bolts ????really i would of thought they would just snap off at that torque ?? but again thanks

INCH pounds. At 87 ft-lbs you'd snap them for sure.

It's.... goofy. They don't have the torque units standard across the board, so just be very careful when reading what bolt gets what (again, this is straight out of the manual).

or im i reading this wrong head nuts big torq small bolts small torq or is it head nuts small torq small bolts big torq ?? sorry i just wanna get it done right and not bust anything