TOPIC:

Dogfight here. My email is fullcirclerestorations@bell,net
Thanks

This makes it a 1370 instead of a 1286. So 1400 instead of 1300.

I am in Nova Scotia. I would hazard a guess it would cost about $200 to ship it to Ontario. It is 2 boxes. One weighs 25lbs and one weighs 42lbs.

If you are thinking of doing this as purely a performance gain, its not. Increasing displacement by itself is a marginal performance increase.

However, if you have a bike with low compression or it burns oil then this would be a good way to go about it. If the engine is worn out enough that the head has to come off to deal with it, there is no point in not machining the head. New valve seals. Valves seats and valves reground etc. Instead of just putting new rings in, now you get new rings, pistons and a freshly bored cylinder with a displacement gain + the machined head.

If we are going to do this outside of Ebay and payment through EMT I don't have to worry about the ebay fees and paypal fees I would let it go for $1400 USD plus shipping.

Well ebay has the piston kit for $250.00.

Either its a different kit or it has come down a lot in price. This kit was $600

No eBay APP ID and/or Cert ID defined in Kunena configuration

Tried to put a link to ebay Bigbore kit for $250.00, it's hard put any link on here !!!!!!