|
Welcome,
Guest
|
|
TOPIC:
Float Height Settings............Again ! 4 years 6 days ago #28184
|
It would appear the K Workshop Manual is misleading when it describes the point float heights should be measured from ?
The tollerance is between 6.5 and 8.5mm BELOW the measuring point (so 7.5mm is a good mid way point)................but WHICH measuring point A or B or C ?? Can someone who has done this recently confirm this please as I have always measured from C but maybe wrong ? Why Have Four When You Can Have Six ?
|
|
Please Log in or Create an account to join the conversation. |
Float Height Settings............Again ! 4 years 6 days ago #28185
|
seems pretty straight forward to me. "From the bottom edge of the carburetor body" which from your diagram is "B"
|
|
Please Log in or Create an account to join the conversation. |
Float Height Settings............Again ! 4 years 6 days ago #28186
|
Thanks Kawboy................if only it was a straight forward as that !
See a post by Scotch below, which states very differently ! Interested to hear your comments ? Why Have Four When You Can Have Six ?
|
|
Please Log in or Create an account to join the conversation. |
Float Height Settings............Again ! 4 years 6 days ago #28187
|
The red line indicates aprrox. 7.5mm as does the Green line in the 2nd photo
1980 KZ 1300 sr# KZT30A-009997
Always High - Know Fear ! |
|
Please Log in or Create an account to join the conversation. |
Float Height Settings............Again ! 4 years 6 days ago #28188
|
|
Please Log in or Create an account to join the conversation. |
Float Height Settings............Again ! 4 years 6 days ago #28189
|
|
Please Log in or Create an account to join the conversation. |
|
Time to create page: 0.058 seconds