Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC:

Mixture Screw Caps ?? 5 years 4 months ago #21830

  • strate6
  • strate6's Avatar Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
  • On An Adventure Before Dementia ! !
  • Posts: 1149
  • Thank you received: 356
Cannot remember if it was on this site, but did someone once find a suitable little rubber or plastic cap to fit into the hole above the 6 Mixture Screws, to stop them getting full of crud ?

Thanks

Pete F
Why Have Four When You Can Have Six ?

Please Log in or Create an account to join the conversation.

Mixture Screw Caps ?? 5 years 4 months ago #21844

  • scotch
  • scotch's Avatar
  • Offline
  • Sustaining Member
  • Sustaining Member
  • Posts: 1887
  • Thank you received: 830
Hi Pete ! For what it's worth - I wouldn't worry about these caps. Trying to remove any type of cap/plug will be difficult with the carbs installed. Especially if you just want to "tweak" the mixture. Consider soldering an "Allen-head" to the top of each screw and buy a Ball-end driver to fit. Adjusting the screws is SO MUCH EASIER!


www.kz1300.com/index.php/forum/carburato...crew-conversion#5527
1980 KZ 1300 sr# KZT30A-009997
Always High - Know Fear !

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Time to create page: 0.058 seconds
Powered by Kunena Forum